|
Common Reasons Service Technicians Use
SEA FOAM MOTOR TREATMENT
When your vehicle has a rough idle, hesitates,
stalls, pings or has an after run problem – this
is often due to carbon buildup.
Your service technician can offer a reasonably
priced fuel systems cleaning with the use of
SEA FOAM products
to solve these carbon problems.
When your vehicle’s fuel injectors
need cleaning – this is often due
to residue left on injectors from poor burning fuels and contaminants.
Your service technician can offer an inline
fuel injection cleaning with the use of an injector cleaning machine
and SEA FOAM MOTOR TREATMENT.
SEA
FOAM MOTOR TREATMENT is
also added to the fuel to disperse moisture, clean fuel lines
and injectors while driving.
When moisture needs to be removed from fuels
or an anti gel or de-icer is needed –
these conditions are due to condensation in the fuel tank and extreme
cold weather creating gas line freeze or diesel fuel gelling.
Your service technician can recommend the
use of SEA FOAM MOTOR TREATMENT
in the fuel tanks to dry moisture and cure these problems.
When there is moisture detected in the oil
– this problem is due mostly to
poor ventilation and condensation. Sometimes, however, there is
a bad head gasket, cracked head or block that must be replaced.
Your service technician will diagnose the
problem and recommend the repairs. As part of the diagnostics,
a SEA
FOAM MOTOR TREATMENT can
be used in the oil crankcase to cure the moisture problems. A
SEA
FOAM MOTOR TREATMENT can
also be used in the oil crankcase after repairs to make sure moisture
is eliminated.
When valve lifter noise is apparent or piston
rings seem to be sticking – this
is often due to dirty and gummed up oil passages, varnished lifters
and buildup of gum, varnish and carbon in the piston ring areas.
Your service technician can offer a
SEA FOAM MOTOR TREATMENT
that will clean sticky lifters and free sticky rings. By doing
this treatment you will be able to determine if there is a varnish
problem or a mechanical problem.
To help pass emissions tests
– high emission numbers are usually caused by extreme carbon
build up, dirty emission control items such as: pcv valve, egr valve,
oxygen sensors or bad spark plugs and wires.
Your service technician can provide a pre-emission
test service that includes SEA
FOAM MOTOR TREATMENT as
a cleaning agent to help pass emissions tests.
When fuel stabilization and engine fogging
is needed – fuels of today become
stale in less than thirty days. Therefore, stabilization and engine
fogging are needed when vehicles, lawnmowers, snow blowers, outboard
motors, chainsaws, motorcycles, gas in cans and engines are put
into storage.
Your service technician can provide fuel
stabilization and engine fogging services with
SEA FOAM MOTOR TREATMENT.
|
